Pick and Pluck Foam | Pick N' Pluck Foam
(Do it yourself foam inserts)

Order Pick N' Pluck Foam
(28" x 17" & Larger will be in multiple sections)

x

x

Cut each layer Thick

Foam Type:

Pick and Pluck is a Foam insert that consists of blocks vertically pre-scored high-density foam that can be easily "plucked" to provide a snug fit for equipment and accessories. Pick and Pluck inserts will protect your equipment in even the toughest and most abusive trips. Also known as Pinch & Tear, Diced Foam, Pick N Pluck or Perforated Foam.

Many cases we offer can be purchased with a stock foam set called Pick and Pluck which is very economical for the average buyer. This usually includes three or more layers of foam inserts. Convolute in the lid of the case, and in the base Pick N' Pluck resting on a flat pad. Depending on the size of the case it may include more then one layer of Pick N' Pluck. These foam sets are available in 1 to 3 days. Or go with our Custom Foam Inserts for a more exacting fit. Since the pick and pluck foam inserts are custom cut to your case they are not returnable. Blank foam is also available on request.

Check out our helpful hints on plucking out the foam and be sure to learn about the Different types of Foam before ordering.

Pick and Pluck foam shown in 3 layers. Convolute, Pick and Pluck, Flat Pad.

Diced foam Pack (Pick and Pluck) shown with a hand demonstrating how to pull out the foam cubes.

Should you mistakenly remove too many rows of Pick N' Pluck Foam cubes, they may be replaced by gluing back into place with a clear rubber-base cement or contact spray adhesive, following gluing instructions.

Also Available to Complete your Case:
Flat Foam | Convoluted Foam

Call Us Toll-Free:	1-877-412-2737
	1-877-(41-CASES)

Pick and Pluck Foam | Pick N' Pluck Foam (Do it yourself foam inserts)

Pick and Pluck Foam | Pick N' Pluck Foam
(Do it yourself foam inserts)